All ideas

Add manufacturing tolerances for heads, in accordance with standards NF E81-100 to NF E81-104 (and other national standards). Or be able to define a manufacturing tolerance as a percentage rather than a fixed value.

Update the material database inclouding more grades of Titanium such as grade 12 that is highly used in the industry, also update EN13445 with Titanium, Nickel and similar alloys, joint efficiency and safety factors according to EN13445-9,10,11 an...

Possibility to add a Bolted Domed end according EN 13445.3 clause 12

Add an option to override the selected bolt area. This can be helpful when non standard neck-down bolt is used.

Please can we update the API 650 calculations as well as the user interface. Africa is booming in storage of petroleum. This means we need API 650 more and more here. AutoPIPE can have the edge here compared to other softwares. We can use it as a ...

It would be great if I could make a calculation when I'm finished entering the values ​​for, for example, a shell, a nozzle, an end cap, etc. It would make the work considerably easier when I have nozzles with nozzle loads, then I get a quick over...

We have noticed that the software systematically considers all jackets as type 2 in the jacket closure calculation following ASME VIII -Appendixe 9

It is not possible to set 2.5 Convolutions (N). In some cases, I have to consider bellow with 2.5 convolution, but I cannot design as there is no option to enter this value.

The Software calculate the fiber elongation according ASME SECTION VIII division 1 according UG-79. The term “t” is the nominal thickness for the component. For dished end it is only possible insert the minimum thickness and the calculation of the...

When we have a bogy flanged implemented in a cylindrical shell we need to define a thickness for shell and a thickness for flange (g0). Normally the both thickness are the same and the software only take into account the shell value for internal p...