All ideas

When we have a bogy flanged implemented in a cylindrical shell we need to define a thickness for shell and a thickness for flange (g0). Normally the both thickness are the same and the software only take into account the shell value for internal p...

When selecting the wind code in Autopipe Vessel v45.00.02.004, it is not possible to select the EN 1991 code with British National Annex (BS EN 1991), but there is only an option to select the EN 1991 code. The British national annex provides ...

The Software calculate the fiber elongation according ASME SECTION VIII division 1 according UG-79. The term “t” is the nominal thickness for the component. For dished end it is only possible insert the minimum thickness and the calculation of the...

Ensure that all calculation codes are updated a maximum of six months after their publication

Currently only full penetration welded nozzle can be designed, this feature will enable users to design and perform nozzle opening reinforcement calculations for partial penetration nozzle weld.

Sometimes is needed to increase locally the thickness of the vessel wall to reinforce the nozzles (under pressure load or external loads), instead of increasing the whole course or head thickness (for economic reasons). Simulating this local thick...

Implement FFS as per API 579. Parts of API 579 include: 1 – Introduction 2 – FFS Engineering Evaluation Procedure 3 – Brittle Fracture 4 – General Metal Loss 5 – Localized Metal Loss 6 – Pitting Corrosion 7 – Blisters, HIC, and SOHIC Damage ...

Need to add an option to consider "as formed" and "annealed" bellow This will impact on following parameters and user can choose as per their requirements, ASME Km & Kg factor ASME factor 2.3 or 0.75 for Sy* EJMA Cm factor

Allow the user to inser the combinaton fator for internal pressure (Fp) and the combination factor for external pressure (Fpe) as refered in API 650 paragraph 5.2.2.

Design non circular flanges according EN 13445-4 clause 10.7.