All ideas

In a jacketed vessel, when location of the Nozzle changes, the Parent is set by default. User would like to limit interference as much as possible since it can be source of error. As long as the parent remains a possible candidate, it should not c...

Please provide the option of a T profile for the legs

Nozzles design: Please provide an opction that considers the alternative calculation method when there is an insert forged pad

To generate parts, assembly and drawings with i logic .

They appear in the list of components, the 2D and 3D view. Local loads for them can be checked in Design Component. Their welds appear in the weld map.

While designing heat exchanger as per EN 13445-3, AutoPIPE Vessel is considering elastic modulus at mean metal temperature but elastic modulus values should be taken at design design temperature. Refer attached snap.

The allowable pressure of flanges as per EN1092-1 can be defined by formulas or by table. In the past AutoPipeVessel was giving the table allowable pressure. In the new version, it's the calculation with the allowable stress of the material. It wo...

In the designing of tall structures, especially tall process columns, the use of DIN 18800 proved helpful. This must be notified though, that this standard is out of use, and has been superseded by EN 1993-1-6 for a while.Kindly please add this to...

Allow the use of Alternative Pressure Area Design Method if the primary method of assessment for PD5500 shows non-compliance. The alternative method is less conservative and therefore may in some cases be able to sufficiently demonstrate compliance.

Upload of the Autopipe Vessel loads version 43.01 and higher was no longer possible to submit the loads of the nozzles directly to nozzle PRO PRG 2023.2.0.1005. So, this idea is to make the Autopipe Vessel new version to be compatible with Latest ...