All ideas

Need to add an option to consider "as formed" and "annealed" bellow This will impact on following parameters and user can choose as per their requirements, ASME Km & Kg factor ASME factor 2.3 or 0.75 for Sy* EJMA Cm factor

Currently only full penetration welded nozzle can be designed, this feature will enable users to design and perform nozzle opening reinforcement calculations for partial penetration nozzle weld.

When selecting the wind code in Autopipe Vessel v45.00.02.004, it is not possible to select the EN 1991 code with British National Annex (BS EN 1991), but there is only an option to select the EN 1991 code. The British national annex provides ...

MANDATORY APPENDIX 13 VESSELS OF NONCIRCULAR CROSS SECTION Rectangular cross section vessels.

Sometimes designers want to create a custom flange specially for large diameter nozzle which can then be checked as a body flange (Appendix 2 etc.). Currently this can be done as a separate model but an option to include custom flange to a nozzle ...

MDMT Calculation for the floating head components (cap, flange, split ring, floating tubular plate, etc.) does not appear only external body MDMT calculated. Please add MDMT Calculation for the floating head components

Update the material database inclouding more grades of Titanium such as grade 12 that is highly used in the industry, also update EN13445 with Titanium, Nickel and similar alloys, joint efficiency and safety factors according to EN13445-9,10,11 an...

According ASME Section VIII Div.2 Paragraph 4.1.2 it is required to respect the minimum thickness. At the moment the software doesn’t send any information about that. However for ASME Section VIII Div. 1 the software send the information according...

According ASME Section VIII Division 2 it is required to determine the upper limit for test pressure – ASME SECTION VIII Div.2 Part8 Paragraph 8.2.1 (c). Based on that is important to state on the project documents the value for minimum and maximu...

Please add the possibility to enter the values lt, ht and eat according to EN13445 16.12.4 for the design of skirt. In my attached file, when changing lt to 179.7 mm and eat to 7.7 mm, the formula (16.12-70) is now verified without changing the sk...