All ideas

In the designing of tall structures, especially tall process columns, the use of DIN 18800 proved helpful. This must be notified though, that this standard is out of use, and has been superseded by EN 1993-1-6 for a while.Kindly please add this to...

Allow the use of Alternative Pressure Area Design Method if the primary method of assessment for PD5500 shows non-compliance. The alternative method is less conservative and therefore may in some cases be able to sufficiently demonstrate compliance.

Upload of the Autopipe Vessel loads version 43.01 and higher was no longer possible to submit the loads of the nozzles directly to nozzle PRO PRG 2023.2.0.1005. So, this idea is to make the Autopipe Vessel new version to be compatible with Latest ...

UG-98 (b) asks for taking into account the difference in elevation between the chamber being tested and the pressure gauge. The water level in test should be an input, like the liquid level in operation.

This will assist with electric heaters that are often used in the petrochemical industry as well as in the power generation industry.

MANDATORY APPENDIX 13 VESSELS OF NONCIRCULAR CROSS SECTION Rectangular cross section vessels.

Sometimes designers want to create a custom flange specially for large diameter nozzle which can then be checked as a body flange (Appendix 2 etc.). Currently this can be done as a separate model but an option to include custom flange to a nozzle ...

It should be possible to impose a weld bead dimension in the "brackets and lifting accessories" masks. This value is set at 0.7 x the minimum thickness of the shell or wear plate. In the case of large thicknesses, this results in an unfeasible wel...

On many occasions, we find horizontal vessels that can be suspended from the ceiling. saddles should be able to be placed on the top of the equipment and should be calculated in traction and not compression.