Skip to Main Content
ADD A NEW IDEA

AutoPIPE Vessel

Showing 71 of 71

Updating API650

Please can we update the API 650 calculations as well as the user interface. Africa is booming in storage of petroleum. This means we need API 650 more and more here. AutoPIPE can have the edge here compared to other softwares. We can use it as a ...
Tristan Northing 9 months ago in  0 Needs review

Lifting accessories – Vertical columns

For vertical vessels I suggest to add a field to add a material for lugs on top o f the vessel and also another field to selected the material for lugs on bottom skirt (tailing lug). It is very common to have columns in for exempla stainless steel...
António Pinho 12 months ago in  0 Needs review

Elastic Modulus considered for EN 13445-3 should be as per Design temperature

While designing heat exchanger as per EN 13445-3, AutoPIPE Vessel is considering elastic modulus at mean metal temperature but elastic modulus values should be taken at design design temperature. Refer attached snap.
Tanaji Gaikwad about 1 year ago in  0 Future consideration

Vessels during transport

In the case of horizontal vessels, it must be possible to lock both sadles in order to carry out a correct calculation under transport conditions (taking into account longitudinal acceleration on both sadles).
Guest 10 months ago in  0 Needs review

Weld dimension on brackets and lifting accessories

It should be possible to impose a weld bead dimension in the "brackets and lifting accessories" masks. This value is set at 0.7 x the minimum thickness of the shell or wear plate. In the case of large thicknesses, this results in an unfeasible wel...
Guest 10 months ago in  0 Needs review

Add API620

When API650 is not suitable for a vertical tank, calculation should be done with API620
Guest about 1 year ago in  0 Needs review

CLAMP CONEXIONS

Just as you can include flanges (EN-DIN-ASME) in the connections, include CLAMP connections (ASME BPE - DIN32676) that are very common in the pharmaceutical industry.
Guest about 1 year ago in  0 Future consideration

Load Combinations -seismic and wind load factors should be adjustable by user

Factors multiplying the wind and seismic loads need to be adjustable by user. Example below in red box shows Load combinations for wind load. Currently this combination is hardcoded in the program.
Sudip Ganguly about 1 year ago in  0 Future consideration

EN1092-1 - Leave the user the choice between table and calculation

The allowable pressure of flanges as per EN1092-1 can be defined by formulas or by table. In the past AutoPipeVessel was giving the table allowable pressure. In the new version, it's the calculation with the allowable stress of the material. It wo...
Guest over 1 year ago in  0 Needs review

Incorporating valid EN 1993-1-6 in place of former DIN 18800-1

In the designing of tall structures, especially tall process columns, the use of DIN 18800 proved helpful. This must be notified though, that this standard is out of use, and has been superseded by EN 1993-1-6 for a while.Kindly please add this to...
Guest over 1 year ago in  0 Needs review